Page 1
Operating Instructions Precipitation Sensors (15188++) Features Weighing precipitation sensor for automatic weather stations • Linearised pulse output, e. g. for connection to external data • loggers Selectable analog output signals, e g. for easy connection to • • Selectable measuring ranges as well as absolute or gliding sum for the analogue output signals Exchangeable, weighing tipping bucket system according to •...
Operating Instructions Precipitation Sensors (15188++) Function Dimensional drawing The weighing precipitation sensor (15188++) measures the rain quantity by a tipping bucket developed by Joss-Tog- nini, the bearings of which have been arranged for low fric- tion. Errors that normally occur due to incomplete draining because of surface tension are automatically compensated by the specific form of the tipping bucket.
Page 3
Operating Instructions Precipitation Sensors (15188++) Assembly of the tipping bucket Attention! In order to protect the tipping bucket the To avoid damage to the tipping bucket during trans- dirt spiral must be inserted in the collection funnel port, it is separately packed and should be inserted (fig.
Operating Instructions Precipitation Sensors (15188++) Electrical connections Initial operation The sensor will be connected to the cable by leading the ca- If the sensor system has been completely mounted and elec- ble through the conduit gland to the connector inside the sen- trically assembled, the sensor will be ready for operation sor housing.
Page 5
Operating Instructions Precipitation Sensors (15188++) Basic settings - fig. 5 Unless otherwise agreed the precipitation sensor (15188++) · Current consumption: ≤ 40 mA will be delivered with following basic settings: · Supply voltage: 18...30 V • max. load 600 Ω ·...
Operating Instructions Precipitation Sensors (15188++) Further setting options J4 J5 J6 J12 Changes of the basic settings are urgently allowed in power-off mode. Only if necessary, changes of the Position 1 2 3 4 5 6 7 8 basic setting should be carried out by skilled techni- Mode cian.
Page 7
Operating Instructions Precipitation Sensors (15188++) Example 1 (Fig. 9): Active analog output 4...20 mA, otherwise like basic setting Fig. 9 Example 2 (Fig. 10): Active analog output 0...5 V, otherwise like basic setting Fig. 10 Example 3 (Fig. 11): Active analog output 0...10 V, otherwise like basic setting Fig.
Page 8
Operating Instructions Precipitation Sensors (15188++) Example 4 (Fig. 12): Low Power Mode - 2 wire circuit · Deactivated analog output · Active pulse output: linearised • bounce-free signal · Current consumpt.: max. 100 μA · typical 50 μm · Supply voltage: 5...30 V Fig.
Page 9
Operating Instructions Precipitation Sensors (15188++) Explanations of the operating modes 3. Gliding sum of precipitation 1. Pulse output At this operating mode the accumulated amount of precipita- The pulse output is permanent activated. The linearised puls- tion, which is updated each minute, is emitted within the se- es are emitted with a pulse duration of 125 ms.
You need a written Date like (15188 W4++) 00.15188.004 050, but in additional permission of the Wilh. LAMBRECHT GmbH for changes with controlled 2-circuit-heating, like (15188 H) of system components. These activities must be operat- Id-No.
Need help?
Do you have a question about the 15188++ and is the answer not in the manual?
Questions and answers