Quick Start - Kurzweil FlashPlay PC 4 SE Getting Started Manual

Controllers
• 88-key fully weighted hammer action keyboard with piano like feel
• Control section with 5 assignable knobs, sliders, and buttons
• Assignable Variation button
• EQ button
• Transpose buttons
• Arpeggiator section with buttons for Arpeggiator Enable, Arpeggiator Latch, CC Sequencer Enable,
and Tap Tempo
• Pitch wheel
• Assignable modulation wheel
• 2 assignable switch pedal jacks (each jack can be used with a dual pedal for up to 4 switch pedals)
• 1 assignable CC pedal jack

Quick Start

Be sure to check the Kurzweil website at
and software updates.
Setting Up the PC4 SE
1. If your PC4 SE keyboard has been out in the cold during shipping, give it time to warm
up to room temperature before powering it on, since condensation may have formed
inside.
2. Place the PC4 SE on a keyboard stand or on a hard, flat, level surface.
3. Connect the DC power adaptor to the PC4 SE DC Power jack.
4. Make sure your power outlet is compatible with the included power adaptor, then plug
the power cable into the power outlet.
5. Plug the included Switch Pedal into the SW1 (SUSTAIN) jack on the PC4 SE rear
panel.
6. If you have an additional switch pedal, plug it into the SW2 jack for Sostenuto control.
7. If you have a MIDI CC pedal (also known as a MIDI expression or volume pedal), plug
it into the CC (VOLUME) jack for volume control.
www.kurzweil.com for new sounds, documentation
Quick Start
Controllers
3