Iarp EIS.3 Use And Maintenance page 9

TEMPERATURE SETTING AND CONTROLS
MODEL EIS 40.3/43.3
Each refrigerating appliance is provided with a thermostat for automatic maintenance of the appropriate
preestablished temperature inside the tank.
This temperature adjuster is gauged by the factory and should not be touched by the user.
Only if the average internal temperature is too cold or not cold enough should the knob by a screwdri-
ver turned. The numbers on the regulation plate are not related to temperature values but only to knob
reference position: a higher number corresponds to a lower temperature.
Defrosting is manual: we recommend a manual defrosting when the frost layer on the refrigerating
shelves or on the tank walls exceeds 5 mm thickness. In order to proceed see 'TANK WASHING'.
4
CONTROLS
1) Supply line led alight: appliance connected
2) Thermometer
3) Thermostat
4) Light switch
MODEL EIS 44.3
Each refrigerating appliance is provided with a thermostat for automatic maintenance of the appro-
priate pre-established temperature inside the tank. This temperature adjuster is gauged by the factory
and should not be touched by the user. Only if the average internal temperature is too cold or not cold
enough should the knob (3) turned. The numbers are not related to temperature values but only to knob
reference position:a higher number corresponds to a lower temperature.
Defrosting of refrigerating shelves is manual: we recommend a manual defrosting when the frost
layer on the refrigerating shelves or on the tank walls exceeds 5 mm thickness. In order to proceed
see 'TANK CLEANING'.
Defrosting on EVAPORATOR group is automatic.
2
1
CONTROLS
1) Light switch
2) Door glass heater microswitch (with switch '1' OFF and door open: glass heater disconnetted)
3) Thermostat
4) Thermometer
5) Defrosting led light (alight during defrosting time on evaporator group)
6) Supply line led alight: appliance connected
10
2 0
30
40
6 5
-9-
6
7 5
0
10
2 0
4
0
3 0
40
3
1
2
4
3