Seasonal Use; Tank Cleaning; Malfunctions And Remedies - Iarp EIS.3 Use And Maintenance

Hide thumbs Also See for EIS.3:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 6

SEASONAL USE

When the unit is not used for a long time, please take note of the following procedures:
-unplug the unit.
-clean and dry the tank well.
-leave the glass door open to avoid possible formation of bad odours.
-cover the unit with a curtain, place it in a dry room and sheltered from the atmospheric agents.

TANK CLEANING

For tank cleaning operations, proceed as follows:
1) Place the goods in special refrigerated containers, kept at
the same temperature and remove the shelves.
2) Unplug the unit.
3) Leave the glass door open and begin the operation of
tank washing when the tank temperature is the same as
the ambient temperature.
4) Remove the draining plug in the tank and the frontal grid;
draining water and remove the internal draining plug.
5) Clean and dry the interior of the tank with a soft cloth, using neutral soap. Then reset the plug,
the discharge tube and the frontal grid; plug the unit and wait till the appliance reaches the right
Warning!
Do not use jet of water or steam to clean the cabinet: electrical wiring could be damaged.
Warning!
Never use mechanical devices or any other means to accelerate the defrosting process, other than those
recommended by the manufacturer.
INFORMATIONS ABOUT SERVICE

MALFUNCTIONS AND REMEDIES

Most of the functioning inconveniences are generally due to defective electrical connections.
These problems can usually be solved on the place.
The unit does not start:
-check that there is voltage at the wall socket;
-check that the unit is properly plugged.
The internal temperature is not cold enough:
-check that the unit is not placed too close to any heating source;
-check the temperature setting;
-check that behind the cabinet air can properly circulate;
-check the perfect closing of the glass door.
The unit is noisy:
-check that all the bolts and nuts are properly fasten;
-check that the unit is placed on an even surface;
-check if any pipe or fan is in contact with any other part of the body.
-8-

Advertisement

Table of Contents
loading

Table of Contents