Table of Contents
Advertisement
6. Starting the calibration
programme
It is important to calibrate the washer-
dryer to ensure optimum water and
energy usage, as well as optimum
washing and drying results.
To do this, the Cottons programme
must be run without laundry and
without detergent.
No other programmes can be started
until calibration has been carried out.
The following message appears in the
display:
Turn on the tap and run the Cottons 90°C
programme without any laundry
Confirm with the OK sensor.
The display will then change to the
standard display for the Cottons
programme.
Washing
Temperature
90 °C
Cottons
TwinDos
Whites
1:57
h
Timer
Turn on the tap.
Touch the Start/Stop sensor.
The calibration programme will start. It
will take approximately 2 hours.
At the end of the programme the
following message will appear in the
display:
Set-up completed
Reach under the door grip and pull
the door open.
Useful tip: For safety reasons, close the
door when the machine is not in use.
Otherwise there is a danger of objects
being placed inadvertently in the drum.
If these remain unnoticed and were
washed in the next load, they could
damage the laundry. An open door is
also a danger to pets and children.
Switch the washer-dryer off with the
11:02
sensor.
Spin speed
1600
rpm
Extras
not selected
Save
Before the first use
29
Advertisement
Table of Contents
