Table of Contents
Advertisement
SAFETY : Read this First !
Chimney assembly
Service agent or similarly qualified persons in order to avoid a hazard.
There shall be adequate ventilation of the room when the range hood is used at the
same time as appliances burning gas or other fuels (not applicable to appliances that
only discharge the air back into he room);
There is a fire risk if cleaning is not carried out in according with the instructions.
No flame allowed under the range hood.
The appliance supports maximum 4 hob element .
Vent System Requirements
Determine which venting method is best for your application. Vented (non-
recirculation) system must be terminate to the outside. Ductwork can extend either
through the wall or the roof. Do not terminate the vent system in an attic or other
enclosed area.
The length of the ductwork and the number of elbows should be kept to a minimum
to provide efficient performance. The size of the ductwork should be uniform. Do
Upper chimney
not install two elbows together. Use duct tape to seal all joints in the ductwork sys-
Slightly widen the two sides of the upper chimney and hood them behind
tem. Use caulking to seal exterior wall or floor opening around the cap.
the mounting brackets, ensuring that they are well seated.
Secure the sides of the brackets using 4 screws (M3 X 12) supplied.
Flexible ductwork is not recommended. Flexible ductwork creates back pres-
sure and air turbulence that greatly reduces performance.
Lower chimney
Make sure there is proper clearance within the wall or floor for exhaust duct before
Slightly widen the two sides of the chimney and hook them between the
making cutouts. Do not cut a joist or stud unless absolutely necessary. If a joist or
upper chimney and the wall, ensuring that they are well seated.
stud must be cut, then a supporting frame must be constructed.
Fix the lower parts laterally to the hood body using 2 screws (ST4 X 8)
supplied.
(Continued)
5
13
Advertisement
Table of Contents
