Connect The Sensors With Display Console; Sensor Operation Verification - Raddy WF-100C Lite User Manual

2) Plug in the Display Console with adapter
Note: It is recommended to plug in the power adapter to reduce the battery
consumption and extend the service life.
Note: If the power adapter is plugged in, BL ON will display in the Time area for
three seconds when power up. Conversely, the icon

3.4.3 Connect the Sensors with Display Console

Once the display console is powered up, it will automatically scan the nearby
Integrated Outdoor Sensors.
When connected with the Integrated Outdoor Sensor, the measured values (Outdoor
temperature, Humidity, Rainfall, Pressure, Wind speed, Wind direction,etc) will show
up on the display console.
Note: Make sure that place the distance between the weather station sensor and
the display console is about 3m-30m. If the weather station is too close or too far
away, it may not receive a proper signal.
Note: DO NOT press any menu buttons until the outside sensor report
display on the screen, otherwise the outdoor sensor will be terminated to
connect with the console.

3.5 Sensor Operation Verification

The following steps verify proper operation of the sensors prior to install the sensor
array.
1. Verify proper operation of the rain gauge. Tip the sensor array back and forth
several times. You should hear a "clicking"sound within the rain gauge. Verify the
rain reading on the display console is not reading 0.00. Each "click"represents 0.1
inch of rainfall.
2. Verify proper operating of the wind speed. Rotate the wind cups manually or with
a constant speed fan. Verify the wind speed is not reading 0.0.
will display .
9