Denso BHT-100B User Manual page 75

Marker
You may select the marker ON/OFF mode from the following:
0: Driven by the trigger switch
1: Fixed to ON
2: Fixed to OFF
If you select "1" (Fixed to ON), the markers will keep ON so that power consump-
tion is higher than that in other modes and the battery working time becomes short.
Do not disturb this setting unless necessary.
View Finder
If the View Finder is set to ON, the LCD shows the scanned image of a code lying inside
the scanner's view when you scan the code. Upon completion of scanning, the view
finder display goes off.
Setting the View Finder to ON decreases the scanning speed.
You may set the view finder also by using the OUT statement in BHT-BASIC.
Option Data
If the Option Data is set to ON, the BHT-100Q will add option data (containing 2D code
model and error correction level) to the tail of 2D code data when it reads a 2D code.
This setting takes effect not only in the reading test in System Mode but also in any
other operations. Do not disturb this setting unless necessary.
• QR code
Data read
1 2 3
Example: If a code read is "QR code, Model 2, Version 5, Error correction level M, and
mask number 6," then the option data below will follow.
(Data read)... Q2V05M6
Chapter 2. Getting Started the BHT and System Mode
Option data format
n+1 n+2
n-1 n
"Q" Model
59
Option data
n+3 n+4 n+5 n+6
Error
correc-
Version
tion
level
n+7
Mask