Midland 70-066 Manual page 51

Parts Needed for 6 Meter conversion of Receiver Board:
Midland 70-066 Parts:
Capacitors.
2.2pf - 2 of
5.6pf - 2 of
8.2pF - 3 of
22pf - 3 of
NOTES:
If your transceiver has a 2.5 Khz step frequency, then your receiver should have a narrow pass filter,
eg 5 Khz. Thus when you receive normal 10 Khz deviation signals – they will sound distorted, get the
sending operator to back off from the microphone.
The Receiver Board:
Partially remove the receiver board from the Midland 70-066 transceiver below. ie. Remove all white
plugs connected to the white sockets on the board. Then remove all screws holding the receiver board to
the transceiver chassis. NOTE: - Do not unsolder the power cables to the receiver board.
Midland 70-066 Receiver Board - below.
Midland 70-066 low Band Conversion to 6 Meters: Receiver Ver 2.1 20-nov-09 Part 3 Page 3.1
Jaycar
RC-5304 Note:
RC-5309
RC-5311
RC-5216
All capacitors are 50V Ceramic