Advertisement
Markers.
Masking Tape.
Marking Pen. [for putting coil numbers on Masking tape in Tx PA section]
Drill Bit. Size – 5mm
If your transceiver has no FUSE attached to the power cable, you are advised to purchase & install one
before you test the transceiver.
Parts needed First Night:
For Synthesizer:
2 of 22pF ceramic Capacitors
1 of 5.6pF ceramic Capacitor
1 of 24 pin low profile socket
Approximately 100 mm of 0.63mm [22bs] enameled coated wire [Jaycar WW4018].
Masking Tape.
Marking Pen. [for putting coil numbers on Masking tape in synthesizer section and marking panels &
PCB's]
Drill Bit Size – 5mm
Small plastic bag to keep screws and coils in.
A4 plastic bag to keep covers in.
12 volt power cable with Molex plug [approx 1 meter] if a Midland 70-066 and an in-line 10Amp
fuse, will be needed in aprox three weeks for testing the transceiver.
Midland 70-066 low Band Conversion to 6 Meters: - Introduction Part 1
Jaycar RC-5216
Jaycar RC-5309
Jaycar PI-6506
Page 1.5
Advertisement
