Advertisement
It has been suggested by Ken VK2KJ, that if you cannot locate a Molex plug for the midland 70-066
transceiver - Remove the power socket female pins by using a very small jeweler's screwdriver to bend
back the locking fins. This is made easier by reshaping the pin socket diameter to gain access to the fins.
When both fins are pushed down the pin will retract from the rear of the socket. Feed the new power
cable through the Molex socket and through the socket end of the pin soldering the cable to crimp area.
Now open the fins slightly and pull cable back to lock the pin into position. The same can be carried out
for the speaker jumper for those who are not using remote speaker.
Midland 70-066 low Band Conversion to 6 Meters: - Introduction Part 1
Page 1.16
Advertisement
