Advertisement
Available languages
Available languages
3. Set the dispensing mode selector switch to the appropriate volume of mortar for discarding
Discard the amount of mortar stated in the instructions for the foil pack.
One click of the dispensing wheel corresponds to 1 ml.
4. Discard the initially dispensed volume of mortar.
6
Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1
Injecting mortar
For each new foil pack and each new cartridge and if the mortar has hardened inside the mixing
nozzle, always use a new static mixer (mixing nozzle).
1. Press the trigger.
2. Inject the mortar.
6.2
Removing the foil pack holder and foil pack
1. Set the dispensing mode selector switch to
2. Press the release button.
3. Pull the piston rod back as far as they will go.
4. Swivel the foil pack holder up.
5. Remove the foil pack.
6. Press the tab on the foil pack holder.
7. Press the foil pack holder down at the rear locating lug.
8. Pull the foil pack holder down from the front locating lug.
6.3
Removing the cartridge
1. Set the dispensing mode selector switch to
2. Press the release button.
3. Pull the piston rod back as far as they will go.
4. Swivel the cartridge upwards.
5. Press the cartridge down at the rear locating lug.
6. Pull the cartridge down from the front locating lug.
7
Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care of the product
•
Carefully remove stubborn dirt.
•
Carefully clean the ventilation slots, if present, with a dry brush.
•
Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
•
Oil the piston rods when necessary.
Care of the Liion batteries
•
Never use a battery with clogged ventilation slots. Clean the ventilation slots carefully using a dry, soft
brush.
•
Avoid unnecessary exposure of the battery to dust and dirt. Never expose the battery to high levels of
moisture (e.g. by being dipped in water or left in the rain).
If a battery has been soaked by moisture, treat it as a damaged battery. Isolate it in a non-flammable
container and consult Hilti Service.
*2330326*
6
.
8
.
2330326
7
.
English
9
Advertisement
