Advertisement
Quick start guide
Before you start
•
Register on the
and then download and install
ModusToolbox™ software v2.4
(or later) from
https://www.cypress.com/
products/modustoolbox.
Download and install the code example
•
Do the following to download and
install the 'Hello World' code example.
a. In Eclipse IDE for ModusToolbox™
software, select File > New >
ModusToolbox™ Application.
This launches the project creator.
b. In the project creator, click
AIROC™ Connectivity BSPs.
c. Select the 'CYW943907AEVAL1F'
kit and click Next.
d. Select a code example
(e.g.,
'Hello World').
e. Click Create and then click Close.
Note: The kit is pre-programmed
with the 'Hello World' application.
Connect the kit
•
Connect a USB cable between the
PC and CYW943907AEVAL1F (J5)
to power the kit.
Run the code example
1. Open a terminal emulator
with a baud rate of 115200.
2. Observe that the LED blinks with a
period of 2 seconds and the serial
terminal shows the console message.
3. Press any key to pause and resume
LED blinking.
Developer Community
Infineon Developer Community
ModusToolbox™ software
Kit connected to PC
Configure the terminal emulator
'Hello World' application
Advertisement
