Test Run - EuroLite LED Space Ball 20 User Manual

Install the Space Ball, connect a DMX controller and switch on the hoist. The winch moves to a defined starting
position.
To test the DMX connection, pull up the channel
fader 6 and observe the Space Ball's
movement, then move the fader back down to 0.
Set channel fader 8 to a value between 240
and 245 and reset the winch. In case of any
malfunction, check the DMX connection.
Flashes in case of missing signal

TEST RUN

Step 1
Lights up after power on
Indicates DMX address
Step 2
Set value
to 20.
Step 3
Reset with
240-245.
Correct starting position.
24 • EN
The Space Ball should move up
and down.
Wrong starting position.