Furuno IF-2550 Installation Manual page 5

Input/Output
Mode
Input
IF-2503 1
MD-550 1
IF-2550 1
Converting 1
AD-10 to
NMEA0183
Sentence 3
*3*4
inverting
*1
: A contact signal used for alarm management from an alarm-compatible device to an AMS (Alarm
Management System).
*2
: A contact signal used by AMS (Alarm Management System) for alarm management for alarm-
compatible devices.
*3
: Available when the contact signal is input from the REM / INV port.
*4
: Set with DIPSW2 by connecting a single pole single throw switch (local supply) between pin 13
(REM / INV_H) and pin 14 (REM / INV_C) of TB4 so that current flows only when the switch is closed.
It is also possible to invert the sentence of the target.
Baud Rate
Output
8 4800 bps/38400 bps
(NMEA0183)
8 4800 bps to 38400
bps (NMEA0183)
8 4800 bps
(NMEA0183 to CIF)
2400 bps/4800 bps
(CIF to NMEA0183)
8 38400bps
(NMEA0183)
8 Either IF-2300 or
IF-2500 settings
NMEA
0183 Ver.
Ver.1.5/2.0/3.x/4.x
(Through)
Ver.1.5/2.0/3.x/4.x
(Through)
Ver.1.5/2.0
(Selecting by
DIPSW1)
Ver.1.5/2.0/3.x/4.x
(Through)
Either IF-2300 or
IF-2500 settings
3
Remarks
* 1
Supports Local ACK
* 2
Remote ACK . System
fail/Data through/Alarm
output control /Internal
status output/Remote ACK
input functions can be used.
Baud rate is switched by
DipSW1.
Not only IEC61162-1/2
standard signal distribution
but also AD-10 four
distribution is possible.
Supports One input, Four
outputs, Two lines and One
input Eight outputs and One
line. The setting of the baud
rate setting is not required.
Mutual data converting
between CIF and
NMEA0183. Inputted CIF or
NMEA0183 data can be
mixed and outputted.
Converting AD-10 to
NMEA0183 (HDT, VWH) .
When the ship turns 180 °,
the following sentences
whose bow direction is the
reference for measurement
are converted to the bow
direction after the turning.
・ HCR, HDG, HDM, HDT,
THS
・ VBW
・ GPatt
・ MWV, VWR, VWT
and