Furuno IF-2550 Installation Manual page 12

4. Secure the cable to the cable clamp with two cable ties per cable (supplied, see following
figure).
5. Depending on the installation and configuration, do one of the following:
・ No DIP switch or Pin setting required; LED check not required: Fit the cover
then fasten the four screws removed at step 1.
・ To Check the LED, see "10. LED INDICATIONS".
・ To set the jumper pins, see "9. SETTING THE JUMPER PINS".
・ To set the DIP switches, see "8. SETTING THE DIP SWITCHES".
The securing position of the cable
10
Cable
ties