Guiding Signals - Dell S300 User Manual

Guiding Signals

Projector Status
Standby mode Projector in Standby mode. Ready to power on.
Warming up mode Projector takes some time to warm up and power
on.
Lamp on Projector in Normal mode, ready to display an
image.
Cooling mode Projector is cooling to shutdown.
Power Saving mode Power Saving mode has been activated. The
projector will automatically enter standby mode, if
an input signal is not detected in two hours.
Cooling before The projector takes 60 seconds to cool down before
Power Saving mode entering Power Saving mode.
Projector Air vents might be blocked or ambient temperature
overheated may be above 35ºC. The projector automatically
shuts down. Ensure that the air vents are not
blocked and that the ambient temperature is
within operational range. If the problem persists,
contact Dell.
Lamp driver The lamp driver is overheated. The air vents may
overheated be blocked. The projector automatically shuts
down. Turn the display on again after the projector
cools down. If the problem persists, contact Dell.
Fan breakdown One of the fans has failed. The projector
automatically shuts down. If the problem persists,
contact Dell.
Lamp driver The lamp driver has failed. The projector
breakdown automatically shuts down. Unplug the power cord
after three minutes then turn the display on again.
If this problem persists, contact Dell.
Color Wheel Color wheel cannot start. The projector has failed
breakdown and the projector automatically shuts down.
Unplug the power cord after three minutes and
then turn on the projector. If this problem persists,
contact Dell.
Fault - DC supply Power supply has been interrupted. The projector
(+12V) automatically shuts down. Unplug the power cord
after three minutes and then turn on the projector.
If this problem persists, contact Dell.
Lamp module Lamp module connection may be disrupted. Check
connection failed the lamp module and ensure that it is properly
installed. If the problem persists, contact Dell.
Description
Note: The OSD menu is not accessed.
Control
Buttons
Power
BLUE
Flashing
BLUE
BLUE
BLUE
AMBER
Flashing
AMBER
OFF
AMBER
ÒFF
AMBER
Flashing
BLUE
AMBER
Flashing
OFF
Troubleshooting Your Projector
Indicator
TEMP LAMP
(Amber) (Amber)
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
AMBER OFF
AMBER OFF
AMBER
OFF
Flashing
AMBER
OFF
Flashing
AMBER AMBER
Flashing Flashing
AMBER AMBER
AMBER
OFF
Flashing
67