Toshiba RAC-WK1823ESCWRU User Manual page 17

Left
Locknut
Sill Angle
Bracket
Flathead Bolt
Fig. 14A
Measure from
Window Sash
the cabinet
edge
Window Sill
Fig. 15
Fig. 16
5. Secure Accordion Panels
Locking Screw
User Manual
1/2" Long Screws
and Locknuts
Right
2 Each Required For
Each Support Bracket
About 1 1/4" to 1 5/8"
Side
Sill Angle
Louvers
Bracket
1/2" Long
Screws and
Locknuts
7/16"
Locking
Screw and
Washer
Fig. 17
B. Assemble sill angle bracket to support brackets
at the marked position (Fig. 14A). Hand tighten
only so adjustments can be made later.
NOTICE
Check that air conditioner is tilted back
about 1-1/4 in to 1-5/8 in (tilted about 3° to
4° downward to the outside). After proper
installation, condensate should not drain from
the overfl ow drain hole during normal use.
Adjust the slope if otherwise (Fig.15).
C. Install support brackets (with sill angle
brackets attached) to correct hole in bottom
of cabinet as shown in Fig. 16.
D. Tighten all 6 bolts securely.
A. Carefully raise window to expose accordion
panel locking screws. Loosen screws so
accordion panels slide easily.
B. Extend panels to fi ll window opening
completely. Tighten locking screws on top
(Fig. 17).
C. Close window behind top rail.
Page 17