Toshiba RAC-WK1823ESCWRU User Manual page 11

The indicator light adjacent will be illuminated and
remain on once the mode is selected.
When the unit is turned off and back on via the power
button, the unit will automatically switch on the Energy
Saver function for the following modes:
Cool, Dry, Auto.
When operating on Auto mode:
- When you set the air conditioner to AUTO mode,
it will automatically select cooling or fan only
operation depending on what temperature you
have selected and the current room temperature.
- The air conditioner will control room temperature
automatically according to temperature you've set.
- The fan speed is automatically controlled based on
the temperature setting and room temperature and
cannot be adjusted.
When operating on Fan Only:
- Use this function when cooling is not desired, such
as for room air circulation or to exhaust stale air (on
some models, remember to open the vent during
this function, but keep it closed during cooling for
maximum cooling effi ciency.) You can choose any
fan speed you prefer.
- During this function, the display will show the actual
room temperature, not the set temperature as in the
cooling mode.
- In Fan Only mode, the temperature is not adjusted.
When operating on Dry mode:
- In this mode, the air conditioner will generally
function as a dehumidifi er. Since the conditioned
space is a closed or sealed area, some degree of
cooling will occur.
TIMER: AUTO START/STOP FEATURE:
- When the unit is on, press the Timer button. The
"Timer off " LED indicator light will illuminate
indicating the Auto stop feature has been activated.
- When the unit is off , press the Timer button. The
"Timer on" LED indicator light will illuminate
indicating the Auto start feature has been activated.
- When the time of TIMER ON is displayed, press the
Timer button again. The TIMER OFF indicator light
illuminates. It indicates the Auto Stop program
has initiated.
- Press or hold the UP (
change the Auto time by 0.5 hour increments, up to 10
hours, then at 1 hour increments up to 24 hours. The
control will count down the time remaining until start.
User Manual
) or DOWN ( ) button to
- The selected time will register in 5 seconds,
and the system will automatically revert back
to display the previous temperature setting or
room temperature when the unit is on. (when
the unit is off , there is no display.)
- Turning the unit ON or OFF at any time or
adjusting the timer setting to 0.0 will cancel
the Auto Start/Stop timed program.
NOTICE
To cancel timer operation, press and hold the
timer button for 2 seconds until the beep/
buzzer is heard.
Displays
DISPLAYS
DISPLAYS:
Shows the set temperature in "°C" or "°F" and the
Auto-timer settings. While on Fan Only mode, it shows
the room temperature. If the room temperature is too
high or low, it will display"HI" or "LO".
Error codes:
AS - Room temperature sensor error - Unplug the
unit and plug it back in. If error repeats, call
for service.
ES - Evaporator temperature sensor error -
Unplug the unit and plug it back in. If error
repeats, call for service.
NOTICE
• To change the AC between Celsius and
Fahrenheit scales, press the temperature
control arrows at the same time for 5 seconds.
• If the unit shuts off unexpectedly due to the
power outage, it will restart with the previous
function setting automatically when the
power resumes.
Page 11