Dell Alienware Area-51 Manual page 45

1
2
3
1 PCI Express x16 card
2 retention mechanism
NOTE: If you are not replacing a card, install a filler bracket
in the empty card-slot opening.
To replace a card:
1. Remove the filler bracket to create a card-slot opening (if applicable).
2. For information on configuring, customizing, and making internal
connections on the card, see the documentation that shipped with the card.
3 PCI Express x16 connector
CHAPTER 5: INSTALLING ADDITIONAL OR REPLACEMENT COMPONENTS
3. Align the card with the connector on the system board.
4. Place the card in the connector and press down firmly. Ensure that the card
is firmly seated in the connector.
If you are installing the PCI Express card into the x16 card connector, gently
push the retention mechanism and place the card in the connector.
5. Connect any cables that should be attached to the card (if applicable).
6. Push the shroud to snap it into place.
7. Close the side panel (see "Opening and Closing the Side Panel" on page
8. Connect the computer and devices to electrical outlets, and then turn
them on.
38).
045
/
045