Lucent Technologies MAP/100P Instructions Manual page 7

Recovering from Removing the Wrong Hard Disk Drive
MAP/100P RAID System Recovery - 7
If, while attempting to replace a failed hard disk drive, you remove the wrong hard disk drive,
the system will crash.
To recover from removing the wrong hard disk drive:
1.
Remove power from the
2.
Replace the incorrectly removed hard disk drive.
3.
Remove the failed hard disk
4.
Place the empty hard disk drive assembly bracket back into the MAP/100P.
NOTE: NOTE:
Do not install the replacement hard disk drive at this point.
5.
Reboot the system.
6.
Press ALT-R after the POST.
The system displays the
7.
Select:
Tools
Recovering from Removing the Wrong Hard Disk Drive
system.
drive.
RAID Controller Settings Main Menu.
Continue, press PAGE DOWN.
November 1999
Issue 2