Lucent Technologies MAP/100P Instructions Manual page 3

Recovering from a Single Hard Disk Drive Failure
AT T E NT ION
OBSERVE PR ECAUTIONS
FOR HANDLING
E LE C TROSTAT IC
SE N SIT IVE
D EV IC ES
MAP/100P RAID System Recovery - 3
To recover from a hard disk drive failure:
1.
Identify the failed hard disk
2.
Remove the failed hard disk
NOTE: NOTE:
If you removed the wrong hard disk drive, the system will
crash immediately. See
Wrong Hard Disk
3.
Install a new hard disk
The system should automatically rebuild the hard disk drive. The hard disk drive LED
will flash to indicate the rebuild activity.
4.
If the system does not automatically rebuild the hard disk drive, contact your remote
maintenance center.
Recovering from a Single Hard Disk Drive Failure
drive.
drive.
Recovering from Removing the
Drive.
drive.
Procedure completed.
Issue 2
November 1999