Advertisement
Quick Links
Advertisement
Related Manuals for Walker Edison BQATT
Summary of Contents for Walker Edison BQATT
- Page 1 Item #: BQATT Revised 10/2020...
-
Page 3: Parts List
Parts List Part 1: Headboard Panel Part 2: Slat Set (7 slats) Part 3: Side Rail Part 4: Down Rail Part 5: Cross Bar Part 6: Up Rail Part 7: Legs Part 8: Headboard Lefth Feet Part 9: Headboard Rigth Feet Part 10: Footboard Lefth Feet Part 11: Footboard Rigth Feet Part 12: Slat Set (6 slats) - Page 4 10x40 mm Wood dowel 08 pçs 08x40 mm Wood dowel 16 pçs 1/4"x70 mm Headless bolt 20 pçs Washer 20 pçs 22 pçs Hex Key 01 pçs Spanner 01 pçs 3,5x35mm Screw 24 pçs 4,0x16mm Screw 08 pçs Metal Support 02 pçs 7,0x50mm Bolt...
- Page 5 Step 1 Insert wood dowels (A) into parts (03 and 04). Step 2 Insert wood dowels (B) into parts (01 and 06).
- Page 6 Step 3 Insert Headless (C) into parts (08,09,10 and 11).
- Page 7 Step 4 PLEASE , Check the holes position PLEASE , Check the holes position CAREFULLY CAREFULLY Assemble the parts 06, 01 and 04 on the feet 08 and 09. Step 5 Insert washer (D) and nut (E) as in the picture. After use Spanner (G) to tighten.
- Page 8 Step 6 Rotate the Headboard 180 degrees. Step 7 Insert washer (D) and nut (E) as in the picture. After use Spanner (G) to tighten. Repeat the same process at both sides.
- Page 9 Step 8 PLEASE , Check the holes position PLEASE , Check the holes position CAREFULLY CAREFULLY Assemble the parts 06 and 04 on the feet 10 and 11. Step 9 Insert washer (D) and nut (E) as in the picture. After use Spanner (G) to tighten.
- Page 10 16mm Step 10 Use screews (I) to fix (J) hardware. Repeat this process at two parts. Step 11 50mm Attach central support 05 to feet 07 using wood joint connectors (K). P.10...
- Page 11 Step 12 Assemble the parts 03 on the Headboard (1st) Insert washer (D) and nut (E) as in the picture(2nd). After use Spanner (G) to tighten. Assemble the Footboard (3rd) and Insert washer (D) and nut (E) as in the picture(4th).
- Page 12 Step 13 Insert Bolt (L) and nut (E) as in the picture. After use Spanner (G) to tighten. Repeat the same process at both sides. Step 14 InVisually identify the two sets of slats. P.12...
- Page 13 Step 15 35mm Position the set slat 02 and align as shown in picture (1st) Position the set slat 12 and align as shown in picture (2nd) Repeat this process at two sides. Use screews (H) to fix all indicated slats. P.13...