Advertisement
5. Close the Top Cover gently, then press the [FEED] button to check
the media feeds correctly.
FEED Button
There are three issue modes available for this printer.
CAUTION!
Batch mode:
To separate the printed
media from the printer in
In the batch mode, the media is continuously printed and fed until the
batch mode, be sure to tear
number of prints specified in the issue command has been printed.
the media off at the Media
Outlet or cut the media past
the Strip Plate. If you tear
the media off at the Print
Head by mistake, be sure to
feed one label (10 mm or
more) with the FEED Button
prior to the next issue.
Failure to do this may cause
a paper jam.
E-11
Strip mode (Option):
When printing in strip mode, labels are automatically removed from
the backing paper as each label is printed.
NOTES:
How to set the media
1. When printing labels without
When issuing labels in the strip mode, set the label in the following
removing them from the backing
procedure:
paper, it is not necessary to pass
the media through the Strip Block.
1. Load the media as described on the previous pages.
2. When the media is correctly set,
the backing paper should be
2. Open the Peel-off Unit by pulling it out.
pinched between the Platen and
the Strip Feed Roller as shown
below.
Strip Plate
Label
Strip Feed Roller
Platen
Backing Paper
3. Remove enough labels from the leading edge of the media to leave
20 cm of backing paper free, and insert the top edge of the backing
CAUTION!
paper into the media slot in the Peel-off Unit as shown below.
When opening the Peel-off Unit
for loading the media, be
careful not to drop metal or
other foreign objects, such as a
paper clip into the module, as
this may cause a malfunction of
the printer.
4. Close the Peel-off Unit and Top Cover.
Peel-off Unit
E-12
Advertisement
