Advertisement
3. Pass the media through the Media Guides. Pull the media until it
reaches the front of the printer.
Media Guide
E-9
1. The sensor type used in the last
print job is selected by default.
To change the sensor type, refer
to Section 2.9.1 Media Sensor
Calibration of the Owner's
Manual.
2. The Feed Gap Sensor is
positioned 6.35 mm right from
the media centre.
3. The Black Mark Sensor is
Media Guide
movable over the range of the
media width.
Black Mark Sensor is movable
in the full range.
Be careful not to squeeze the
media with the Media Guides.
Doing so bends the media, which
can cause a paper jam or feed
failure.
NOTES:
4. Check and adjust the media sensor position and select the sensor
type to be used. (Refer to the Owner's Manual.)
This printer has a Black Mark Sensor which can detect black marks
printed on the reverse side of the media, and a Feed Gap Sensor
which detects inter-label gaps.
As the Feed Gap Sensor position is fixed, it is not necessary to adjust
it.
When using the Black Mark Sensor, align it with the centre of the
black mark on the media. Failure to do this will disable the detection
of printed black marks, resulting in an error.
Feed Gap Sensor
6.35mm
NOTE:
E-10
Black Mark Sensor
Advertisement
