Table of Contents
Advertisement
Platter Tare Entry
1. Make sure the Zero and Stable Lamps are on.
2. Place the item you wish to tare onto the platter.
3. Make sure that the Stable Lamp is on.
4. Press the TARE key.
Counting by Unit Weight Entry
1. Make sure the Zero and Stable Lamps are on.
2. Follow the platter or manual tare entry procedures if necessary.
3. Place the parts that you wish to count on the platter.
4. Type the unit weight. You may use the decimal key if necessary.
5. Make sure that the Stable Lamp is on.
6. Press the UNIT WEIGHT key.
Steps 3 & 4 can be interchanged. The balance will now display a unit weight
and a count. The balance may also flash the Ls or Lu Lamps depending on
certain criteria specified on page 4. You can begin counting.
Counting by Sample Entry
1. Make sure the Zero and Stable Lamps are on.
2. Follow the platter or manual tare entry procedures if necessary.
3. Place the parts that you wish to count on the platter.
4. Enter the number of parts that you placed on the platter by using the
numeric keys. You cannot use the decimal key.
5. Make sure that the Stable Lamp is on.
6. Press the SAMPLE key.
Steps 3 & 4 can be interchanged. The balance will now display a unit weight
and a count. You can begin counting.
Counting by Using PLUs
1. Make sure the Zero and Stable Lamps are on.
2. Place the parts that you wish to count on the platter.
3. Enter the PLU number of the part that you wish to count. PLU
numbers range from 0 to 31.
4. Make sure that the Stable Lamp is on.
5. Press the
Steps 2 & 3 can be interchanged. The balance will now display a unit weight
and a count. You can begin counting.
M key.
6
Advertisement
Table of Contents
