Before installation and commissioning
Safety
Danger from incorrect operation and work that is not carried out properly.
This can result in serious personal injury and damage to property.
▶
▶
▶
Setup regulations
Danger from machines toppling over or falling.
This can result in serious personal injury and damage to property.
▶
▶
Danger from electric current.
This can result in serious personal injury and damage to property.
▶
▶
▶
The device is tested to IP 23 protection, meaning:
-
-
Cooling air
The system must be set up in such a way that the cooling air can flow unimpeded
through the slots in the side panels. Ensure that there is always an all-round clearance of
0.5 m (1 ft. 7.69 in.) around the device.
WARNING!
All the work and functions described in this document must only be carried out by
technically trained and qualified personnel.
Read and understand this document in full.
Read and understand all safety rules and user documentation for this device and all
system components.
WARNING!
Set up the device securely on an even, solid surface.
Check all screw connections are tightly fastened after installation.
WARNING!
Ensure the cooling unit is properly insulated.
Always ensure that there is no electrically conductive connection between the base
plate of the cooling unit and the surface.
Before installing the cooling unit, remove all electrically conductive parts between
the base plate of the cooling unit and the surface.
Protection against penetration by solid foreign bodies with diameters greater than
12.5 mm (0.49 in.)
Protection against spraywater at any angle up to 60° to the vertical
33