Table of Contents
Advertisement
Steps
1. Place the display panel and display assembly on a clean and flat surface.
2. Connect the display cable to the connector on the display panel and close the latch.
3. Adhere the tape to secure the display-cable connector latch to the display panel.
4. Lift and rotate the display panel, and then place the display panel on the display assembly.
5. Place the display bezel on the display assembly.
6. Align the tabs on the display bezel to the slots on the display assembly.
7. Press down on the display bezel and snap the display bezel in place.
8. Replace the two (M2x2) screws to secure the display panel to the back cover.
Next steps
1. Install the hinges.
2. Install the
display
bezel.
3. Install the
hinge
caps.
4. Install the
display
assembly.
5. Install the
wireless
card.
6. Install the SSD.
7. Install the
base
cover.
8. Install the
SD
card.
9. Follow the procedure in
eDP cable
Removing the eDP cable (Plastic)
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
4. Remove the
memory
modules.
5. Remove the SSD.
6. Remove the
wireless
card.
7. Remove the
display
assembly.
8. Remove the
hinge
caps.
9. Remove the
display
bezel.
10. Remove the hinges.
11. Remove the
display
panel.
About this task
The following image indicates the location of the eDP cable (in a system shipped with plastic chassis) and provides a visual
representation of the removal procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
65
Advertisement
Table of Contents
