Table of Contents
Advertisement
2. Gently press down on the display hinges to align the screw holes on the display hinges with the screw holes on the palm-rest
and keyboard assembly.
3. Replace the four (M2.5x5) screws that secure the display hinges to the palm-rest and keyboard assembly.
NOTE:
The power-adapter port is secured in place by the left display hinge. There is no screw, tape, or adhesives
securing the power-adapter port to the palm rest. As a result technicians should take note of whether or not the power
adapter port has fallen out of the system during subsequent removal procedures.
4. Route the WLAN antenna cables through the routing guides on the palm-rest and keyboard assembly.
5. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
NOTE:
Ensure to route the speaker cable over the WLAN antenna cables.
6. Connect the display cable to the connector on the system board.
Next steps
1. Install the
wireless
card.
2. Install the SSD.
3. Install the
base
cover.
4. Install the
SD
card.
5. Follow the procedure in
Hinge caps
Removing the hinge caps
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
4. Remove the
memory
modules.
5. Remove the SSD.
6. Remove the
wireless
card.
7. Remove the
display
assembly.
About this task
The following images indicate the location of the hinge caps and provide a visual representation of the installation procedure.
54
Removing and installing components
After working inside your
Before working inside your
computer.
computer.
Advertisement
Table of Contents
