Installation And Assembly; Electrical Connection; Water Connection; Machine Space Limits - Electrolux N7E Installation And Operating Manual

A.6

Installation and assembly

• The operations described must be carried out by personnel qualified (refer to D.1
Characteristics of personnel trained for normal machine use) in compliance with the
current safety regulations, regarding the equipment used and the operating procedures.
• The plug, if present, must be accessible after positioning the appliance in the place of
installation.
• Disconnect the appliance from the power supply before carrying out any installation
procedure.
A.7

Electrical connection

Before connecting, make sure the mains voltage and frequency match those indicated on
the appliance data plate.
• Work on the electrical systems must only be carried out by specialised personnel.
• Connection to the power supply must be carried out in compliance with the regulations
and provisions in force in the country of use.
• If the power cable is damaged, it must be replaced by the Customer Care Service or in
any case by specialised personnel, in order to prevent any risk.
• Verify that a safety circuit breaker is installed between the power cable of the appliance
and the mains electric line. The contact opening max. distance and leakage current
must comply with the local safety regulations.
• Be sure to power the equipment with systems that are protected against overvoltage;
the manufacturer declines all responsibility for effects due to anomalies induced by the
electrical supply system.
A.8

Water connection

(depending on the appliance and/or model)
The appliance must be connected to the water system in compliance with the current
national regulations (and EN1717 for Italy).
• The appliance must be supplied with drinking water at a pressure of 1.5 – 3 bar.
WARNING
The manufacturer declines any liability if the safety regulations are not
respected.
NOTE!
Only for Australia: The appliance shall be installed in accordance with AS / NZS
3500.1 and AS / NZS 3500.2 standards.
A.9

Machine space limits

• A suitable space must be left around the appliance (for operations, maintenance, etc.).
• This space must be increased in case of use and/or transfer of other equipment and/or
means or if exit routes are necessary inside the workplace.
A.10

Positioning

• Install the appliance, taking all the safety precautions required for this type of operation,
also respecting the relevant fire-prevention measures.
• Handle the appliance with care in order to avoid damage or danger to people. Use a
pallet for handling and positioning.
• The installation diagram gives the appliance overall dimensions and the position of
connections (gas, electricity, water). Check that they are available and ready for making
all the necessary connections.
9