HIKVISION DS-7100HQHI-K1 Series User Manual page 78

6. Set the linkage actions. Refer to Configure Alarm Linkage Action for details.
7. Click Apply.
Region Entrance Detection
For certain network cameras, region entrance detection function detects people, vehicles or other
objects which enter a pre-defined virtual region from the outside place, and some certain actions
can be taken when the alarm is triggered.
Steps
1. Go to Configuration → Event → Smart Event → Region Entrance.
2. Set Camera.
3. Turn on Enable.
4. Optional: Check Save VCA Picture to save the captured pictures of VCA detection.
5. Set the detection rules and detection areas.
1) Set Arming Area. Up to 4 arming areas are selectable.
2) Adjust Sensitivity. Sensitivity: Range [0-100]. The higher the value is, the more easily the
detection alarm can be triggered.
3) Optional: Set Target Detection as Human or Vehicle to discard alarms which are not
triggered by human body or vehicle.
Note
This function is only available for certain models.
4) Click Draw Area and draw a quadrilateral in the preview window by specifying four vertexes
of the detection region.
6. Set the arming schedule. Refer to Configure Arming Schedule for details.
7. Set the linkage actions. Refer to Configure Alarm Linkage Action for details.
8. Click Apply.
Region Exiting Detection
For certain network cameras, region exiting detection function detects people, vehicles or other
objects which exit from a pre-defined virtual region, and some certain actions can be taken when
the alarm is triggered.
Steps
1. Go to Configuration → Event → Smart Event → Region Exiting.
2. Set Camera.
3. Turn on Enable.
4. Optional: Check Save VCA Picture to save the captured pictures of VCA detection.
5. Set the detection rules and detection areas.
1) Set Arming Area. Up to 4 arming areas are selectable.
2) Adjust Sensitivity. Sensitivity: Range [0-100]. The higher the value is, the more easily the
detection alarm can be triggered.
Digital Video Recorder User Manual
64