User; Network Configuration; Tcp/Ip - HIKVISION DS-7100HQHI-K1 Series User Manual

4. Turn on Enable.
5. Configure Frame Rate, Max. Bitrate Mode, and Max. Bitrate. The higher frame rate and bitrate
require higher bandwidth requirement.
6. Click Apply.

6.1.3 User

Refer to User for details.

6.2 Network Configuration

6.2.1 TCP/IP

TCP/IP must be properly configured before you operate video recorder over network.
Steps
1. Go to Configuration → Network → General → TCP/IP.
2. Configure network parameters.
Working Mode
Multi-address Mode
The parameters of the two NIC cards can be configured independently. You can select
LAN1 or LAN2 in the NIC type field for parameter settings. You can select one NIC card as
default route. And then the system is connecting with the extranet and the data will be
forwarded through the default route.
Net-fault Tolerance Mode
The two NIC cards use the same IP address, and you can select the Main NIC to LAN1 or
LAN2. By this way, in case of one NIC card failure, the video recorder will automatically
Digital Video Recorder User Manual
Figure 6-3 Channel-Zero
41