Network intercom and pa component with poe support (4 pages)
Summary of Contents for BARIX Annuncicom PS Touch
Page 1
Setup the Device The Annuncicom PS Touch can only be powered over PoE, therefore you need to connect it to a PoE Switch! After some time the Device will announce it's IP Address over the Loudspeaker. When entering the IP-Address into your Browser you will reach the Web Interface of the device, from where you can do the configuration! More Information about Sonic IP can be found here.
Page 2
You cannot switch your PS Touch between IC-Paging and Simple Paging! If you need to change the Firmware type, you will need to send the Unit to the Barix Headquarters. Space: Annuncicom PS Touch Doc, Exported on 25. August 2020 BARIX AG | Ringstrasse 15 A | CH-8600 Dübendorf | T + 41 43 43322 11 | www.barix.com Page 2/ 2...
Need help?
Do you have a question about the Annuncicom PS Touch and is the answer not in the manual?
Questions and answers