Table of Contents
Advertisement
Quick Links
ANNUNCICOM
100
Quick Install Guide
Version 2.0
IP Intercom, Public Address and Paging Device
Package contents
a
Annuncicom 100
b
Power supply
c
RCA adapter for earphone
d
Screw block terminals
Cable Set AUDIO (not included)
e
Earphone
f
RCA stereo cable
g
Network cable
h
Serial cable
Firmware
This device comes preloaded with standard firmware.
Alternative firmware can be downloaded from www.barix.com.
Support
For support please contact your local dealer or visit www.barix.com.
© Barix AG 3/2013, all rights reserved. All information is subject to change without notice. All mentioned trademarks belong
to their respective owners and are used for reference only. Barix, Exstreamer and SonicIP are trademarks of Barix AG, Switzerland,
and are registered in certain countries.
Advertisement
Table of Contents
Related Manuals for BARIX ANNUNCICOM 100
Summary of Contents for BARIX ANNUNCICOM 100
- Page 1 © Barix AG 3/2013, all rights reserved. All information is subject to change without notice. All mentioned trademarks belong to their respective owners and are used for reference only. Barix, Exstreamer and SonicIP are trademarks of Barix AG, Switzerland, and are registered in certain countries.
- Page 2 Front view Rear view Reset button Inputs & Relay A brief press of the button will reset the device. Description Holding the reset button pressed in for approximately 10 seconds will reset the device and restore the factory Dry contact input 0 * default settings when the button is released.
- Page 3 STEP 1 Plug a standard (straight) network cable (g, not included) Most Barix applictaions require no configuration but use into the network port (K) of the Annuncicom and the DHCP to configure network settings dynamically. other end into your hub or switch. You can also use a...
- Page 4 -s 192.168.0.6 00-08-E1-00-B1-77 the user forum please visit www.barix.com. or on a OSX or Linux system type into the terminal arp -s 192.168.0.6 00:08:E1:00:B1:77 and hit the «Enter» key (replace the digits according to your devices MAC address).
Need help?
Do you have a question about the ANNUNCICOM 100 and is the answer not in the manual?
Questions and answers