BARIX annuncicom 100 Quick Install Manual

Network intercom and pa component for commercial, industrial and security applications

Hide thumbs Also See for annuncicom 100:

Download this manual

A N N U N C I C O M

1 0 0

Quick Install Guide Version 1.2

Network intercom and PA component

for commercial, industrial and security

applications

Package contents

a Annuncicom 100

b Power supply

c RCA adapter for earphone

d Screw block terminals

Available cables (not included)

e Earphone

RCA stereo cable

g Network cable

h Serial cable

Support

For support please contact your local dealer or visit www.barix.com.

without notice. All mentioned trademarks belong to their respective owners

and are used for reference only. Barix, Exstreamer and SonicIP are trade-

marks of Barix AG, Switzerland, and are registered in certain countries.

Need help?

Do you have a question about the annuncicom 100 and is the answer not in the manual?

Page 1 Support For support please contact your local dealer or visit www.barix.com. © Barix AG 10/2008, all rights reserved.All information is subject to change without notice. All mentioned trademarks belong to their respective owners and are used for reference only. Barix, Exstreamer and SonicIP are trade-...
Page 2: Front View
Front view Rear view A 1 2 3 4 5 6 B 1 2 3 4 5 6 D 1 2 Reset button Mic & Speaker A brief press of the button will reset the device. Pin Description Holding the reset button pressed in for Microphone input approximately 10 seconds will reset the device Mic Power (Bias)
Page 3: Network Configuration
Installation Network configuration by web browser STEP 1 STEP 1 Plug a standard (straight) network cable (not included) Open your web browser. into the network port (C) of the Annuncicom and the other end into your hub or switch. You can also use a STEP 2 crossover network cable (not included) for a direct Enter the IP address that was announced by the Annun-...
Page 4 Read it to configure the Annuncicom for your purpose. have the IP address “192.168.0.2” and want to check if “192.168.0.6” is free. Check out the Barix user forum on www.barix.com for To do so type ping 192.168.0.6 and hit the additional information.