Communication Equipment, Installation - Volvo EC15E Operator's Manual

Presentation
18

Communication equipment, installation

Communication equipment,
installation
NOTICE
All installation of optional electronic communication
equipment must be performed by trained
professionals and in accordance with the Volvo
Construction Equipment instructions.
Protection against electromagnetic interference
This machine has been tested according to EU's
directive 2014/30/EC that regulates
electromagnetic interference. Therefore, it is very
important that all non-approved electronic
accessories, such as communication equipment,
are tested before they are installed and used, since
they may interfere with the machine's electronic
system.
Guidelines for installing aerial
The guide lines listed below must be followed
during installation:
The position of the aerial must be selected to
provide satisfactory adaptation to the surrounding
area.
The aerial downlead must be of the coaxial cable
type. Make sure that the cable is undamaged, that
the screen is not split at the ends and that it
thoroughly surrounds the contact sheaths and
has good galvanic contact with the same.
The surface between the mounting bracket for the
aerial and the point of attachment must be free
from dirt and oxide. Apply corrosion protection to
the surfaces after installation so that good
galvanic contact is maintained.
Take care to separate cables that may cause
interference from those which may suffer
interference. Cables that may cause interference
are voltage feed cables and the aerial cable to the
communication equipment. Cables that may
suffer from interference are connecting cables for
the electronics of the machine. Install cables as
close as possible to plate surfaces which are
connected to ground (earthed), as these have a
screening effect.