Set Cooking Level With And Without Heat Boost; Turn Off Individual Heaters; Timer Function - Sharp KH-6V13BS00 User Manual

Set Cooking Level With and Without Heat
Boost. All heaters are equipped with a
heat boost functionality.
If the heat boost is active, then the heater
will be operated with maximum power for
the period of the heat boost time, that is
dependent on the selected heat setting.
This is indicated through a flashing ´A`,
alternating with the heat setting value (e.g.
0.5 sec ´A` and 0.5 sec ´9`) in the heater
display. Once the heat boost time ends,
only the heat setting will be indicated.
If the heat boost should be used for a
heater, touch or slide the heat to level 0,
then touch heat level 9 again. After setting
the heat to level 9, ´A` will be indicated
alternating. This means that level 9 and
the heat boost is active now.
The heat boost can be turned off by sliding
your finger across the panel until heat
setting ´0` appears.

Turn Off Individual Heaters

A selective heater can be turned off with
3 different ways:
• Simultaneous operation of the right
and left part of the slider button
• Reduction of the heat setting to ´0` by
press the right and the left part of the
slider button
• Use of timer turn off function for the
corresponding heater
.
.
EN - 13

Timer Function

The timer provides the following features:
The control can run a max. of 4 heater
assigned timers and 1 minute minder
(which is not assigned to any heater)
simultaneously. All timers can be used
only in B-Mode. A heater timer can only
be assigned to an active heater, running
in levels between 1-9. The minute minder
is independent of any heater.
In order to use both functions, the timer
function must be activated by the Active/
Inactive Timer button
Pressing for the fist time after activating
the heaters, the control proposes the
minute minder (no Cooking Zone Indicator
is flashing, they are all on or off).
Pressing for the second time, the
control proposes the assignment to one
of the activated heaters by flashing the
Cooking Zone Indicator. Now the timer
to the linked timer signalised.
Pressing again, the next timer in the
in the clockwise direction, is proposed
for assignment of the next active heater.
And so on...
Minute Minder
No matter whether a heater is activated or
not, the minute minder can be operated
by pressing . The appearing ´00`
shows that timer is active and the dot
.