Table of Contents
Advertisement
General:
Two-handed operation:
Whatever the position of the
machine, always use two hands to
control the machine.
When working with the machine, make sure that the
machine is always held with two hands (see red arrows)
and in such a way that both hands are kept away from
the machining point.
Ensure that the workpiece is securely clamped!
•
for safety reasons
•
to improve the service life of the
carbide inserts
•
to prevent damage to the milling
machine
Important!
Before machining a workpiece, make sure that it is
securely clamped so that it cannot slip.
This should be done to ensure safe working so that the
workpiece does not slip or even fly off when being milled
and to prevent unnecessary vibrations in the workpiece
material.
The less vibration generated in the workpiece, the longer
the service life of the carbide inserts.
To became acquainted with the
machine, you must start by
machining a small bevel with a width
of no more than 2 mm and remember
to advance the machine slowly first.
Bevels of maximum width can only
be machined safely and reliably
once you have become used to
handling the machine.
©
Handling:
Damages caused by wrong power
supply!
•
Check values air connection. The air
pressure must correspondend with the
specifications on the type plate of the
machine.
Improper use can cause serious
injury!
•
Make sure you always have a firm
footing when working with the
machine!
•
Never touch the milling head when the
machine is running!
•
Always lead the machine away from
body during working, never use the
machine above head height.
Risk of damage to equipment and
property!
•
Working with worn or damaged
carbide inserts or milling heads will
cause the machine to fail!
•
Avoid collisions when working with the
machine!
Working with the machine:
Press on-/off-switch (1).
Motor starts. Bring the machine slowly into contact with
the workpiece only after the selected tool speed has been
reached.
Machining the workpiece (up-cut milling)
When milling a bevel always move the machine from left
to right against the direction of rotation of the milling head
(up-cut milling).
Switching off the machine
•
remove the machine from the workpiece.
•
release the on-/off-switch.
•
once the motor is switched off, wait for it to come to a
standstill before placing the machine down on a
surface.
Operating mode
17
Advertisement
Table of Contents
