Settings; Replacing Guiding Roll; Replacing Carbide Inserts; Replacing Milling Body - Gerima SMA 30 BPV-25.L1 Operating Manual

Replacing guidind roll / carbide inserts / milling body
1
Lock spindle
Loosen the guiding roll with hex screwdriver SW5
2
and pull out the guiding roll of the milling body.
Loosen the clamping screws with the Torx wrench
3
T15 and replace the carbide inserts. The inserts
must be fastened to the mounting seat on the mil-
ling head by means of the original locking screws
(max. tightening torque: 4.0–5.0 Nm).
Loosen the milling body retaining screw with the
4
hexagonal wrench SW 5 and remove the milling
body.
In order to avoid cuts and burns when
carbide inserts change, carbide inserts
only change to a complete stop of the
machine. Use protective gloves!
©
Before replacing the machine
must be disconnected from
the compressed air supply
and secured against
reconnection.
Adjusting the 8-fold bevel- and radius carbide inserts
(type KX and RKX):
The bevel- and radius-carbide inserts of type KX and RKX
have 8 cuttings. By rotation and turning it is possible to
use the inserts 8 times.
Consumables and accessories
nr. name of part
Clamping screw
1
CS-30-11
Bevel-carbide insert
2
KX8.B12-V1
Radius-carbide insert
3
R2.5-KX8.B22-V1
Radius-carbide insert
4
R3-KX8.B22-V1
Radius-carbide insert
5
R4-KX8.B22-V1
Bevel/Radius-milling body
6
MC45R6.K3-V1
Bevel-guiding roll
7
GR45.K3-26.30-VC1
Radius-guiding roll 2,5
8
GR45R2.5-28.80-KC1
Radius-guiding roll 3,0
9
GR45R3-28.55-KC1
Radius-guiding roll 4,0
10
GR45R4-27.55-KC1
Torx wrench
11
T15
Hexagon screwdriver
12
SW5
Further carbide inserts, milling bodies and
guiding rolls with special angles and radii
on request.

Settings

order-nr.
0101.203.09-00017
0101.404.18-00031
0101.404.19-00016
0101.404.19-00024
0101.404.19-00026
0101.407.19-00028
0101.403.19-00059
0101.403.19-00064
0101.403.19-00034
0101.403.19-00035
0000.077.14-00001
0000.077.14-00005
15