Connecting The Headphones To A Second Bluetooth ® Device - Silvercrest HG00593A Operation And Safety Notes

You may need to approve the connection on the communication
device. Please refer to the instructions for use of the communica-
tion device on this topic!
If you leave the range of your communication device with your
Bluetooth headphones, the LED will flash red every 2 seconds. If
the connection is not restored within 5 minutes, the headphones
will switch off.
The headphones may be manually switched off by holding the
button for 3 seconds until a beep sounds and the LED goes
out.
Connecting the headphones to a second
Bluetooth
The headphones may be connected to two Bluetooth
devices at the same time. If the headphones are already connected to
a device, follow the steps below to connect to the second device:
Activate multipoint mode by briefly pressing the
pairing mode until four beeps sound.
Now connect to the second device; please note the above
chapter „Using the headphones".
To deactivate multipoint mode: disable the Bluetooth
on the communication device you wish to remove from multipoint
link. If necessary for your purposes, then extend the functions of
the Bluetooth
connected.
14 GB/IE
device
®
transmission of the communication device still
®
communication
®
button in
8
connection
®