Connecting The Headphones To A Second Bluetooth ® Device; Clearing Paired Devices; Connecting The Headphones Through Audio Cable - Silvercrest SBKP 2 A1 Operation And Safety Notes

Connecting the headphones to a second
Bluetooth
The headphones may be connected to two Bluetooth
at the same time. If the headphones are already connected to a device, follow
the steps below to connect to the second device:
Activate multipoint mode by pressing and holding
Acoustic signal sounds. The first communication device (mobile phone or
computer) is disconnected.
Now connect to the second communication device via Bluetooth
headphones. Please refer to the notes in the instructions for your communi-
cation device. Select the entry "SBKP 2 A1" from the list of devices detected
by your computer or mobile. The second communication device is connected
and the headphones emit a confirmation tone.
Press button
communication device is connected again. Now, both communication
devices are connected to the headphones simultaneously.

Clearing paired devices

In paired mode (the LED will briefly flash white twice every 3 seconds),
press and hold
The headphones is now in pairing mode. The LED
Simultaneously pressing and holding
approx. 2 seconds. A signal tone sounds and the LED
white in turn. The headphones are now in pairing mode again.
The memory in the headphones is cleared and it will not auto-connected to
the previous paired communication device.

Connecting the headphones through audio cable

Insert the 3.5 mm jack plug at one end of audio cable
device
®
for three times and acoustic signal sounds. The first
8
button for 2 seconds and acoustic signal sounds.
8
communication devices
®
button
8
flashes white.
4
button and button
8
flashes red /
4
to 3.5 mm socket
13
for 2 seconds.
with the
®
for
6
.
10
GB/IE/NI 15