Table of Contents
Advertisement
4
Wiring
Use this product by connecting to Universal Transmitter SC-U1.
For installation and wiring to SC-U1, refer to the "Universal Transmitter
SC-U1 Installation Manual".
Before wiring, turn off the power switch of SC-U1 or
disconnect the power cable from the supply source and wire
the power cable after all the other wiring is complete.
Connect the sensor to SC-U1.
1
・ The cable clamp fits the cable diameter
of 6 to 8 mm.
・ The sensor cable must be shielded
(CVV-S) with a nominal cross-sectional
area of 0.2 to 1.25 mm
・ Refer to "Extension of sensor cable"
P.11 for extension of the sensor cable.
To extend the sensor cable, connection
using pull box is recommended.
・ Wire the terminal block according to the
color of the tip of each wire.
12
2
.
(Blue) (Brown)(Black) (White)
Sensor
Signal
Power
input
Supply
(RS485)
Sensor
Advertisement
Table of Contents
