Assembled wing end for the user left side Assembled wing end for the user right side Detail D Mini-fix cam. Triangle on cam must be pointing towards the mini-fix bolt to put together. ofs.com imagine a place® 800.521.5381 Assembly instructions...
HK-108, Qty: 3 of mini-fix bolt Detail E Pre-drilled hole for mini-fix bolt Detail F Underside of worksurface where the wing end is on the user left side ofs.com imagine a place® 800.521.5381 Assembly instructions...
To remove the drawer you have to push down (for the right side) and pull up (for the left side) on the tab at the same time while continuing to pull the drawer away from the pedestal. Detail I ofs.com imagine a place® 800.521.5381 Assembly instructions...
E5 BOA assembly Assembled credenza view Right pedestal credenza assembled Left pedestal credenza assembled 2.0625" Overhang from back of pedestal ofs.com imagine a place® 800.521.5381 Assembly instructions...
Assemble wires together from control box to legs. Control Make sure all wires and cords are secured and not hanging below the worksurface. Desk panel Short Long L-bracket L-bracket Foot ofs.com imagine a place® 800.521.5381 Assembly instructions...
Re-install the drawer. HK-109, Qty: 3 of Mod-EZ bolt P-drilled hole Detail J Routed line Underside of worksurface where the end panel is on the user right side ofs.com imagine a place® 800.521.5381 Assembly instructions...
Slide end panel onto back panel. The MOD-EZ bolt will slide into the MOD-EZ clips on the end panel. HK-109, Qty: 3 of Mod-EZ bolt Pre-drilled hole Detail K End panel Back panel Assembly of end panel on the user right side ofs.com imagine a place® 800.521.5381 Assembly instructions...
Back view of E5-1627BBF Detail L Case spacer Needs to be HK-15 screws will go through these pre-drilled holes to flush with attach the pedestal to the each other back panel and worksurface. ofs.com imagine a place® 800.521.5381 Assembly instructions...
Side view - 2" overhang when assembled HK-15 screws will go through these pre-drilled holes to attach the pedestal to the back panel and worksurface. Mod-EZ clip Already installed Detail N Case spacer Detail M ofs.com imagine a place® 800.521.5381 Assembly instructions...
Side view Detail O Step 2 Detail P Once transaction counter is in desired location, tighten the set screw to attach it to the worksurface. Do not over tighten. ofs.com imagine a place® 800.521.5381 Assembly instructions...
Privacy panel flipped upside down Must remove film that is over the suction cup tape before placing it on the worksurface. Make sure the worksurface is clean before placing the privacy panel. Detail Q ofs.com imagine a place® 800.521.5381 Assembly instructions...