On the rear of the unit you can find an XLR jack (DMX out) and an XLR plug (DMX in) used for connecting several devices.
After selecting the master function on the unit you would like to control the others, this device then works as the Master
Device. Set the respective Slave modes for all Slave Devices. Connect the Slave Devices via a balanced microphone lead.
Connect the DMX‐OUT jack with the DMX‐IN plug of the next device.
Note: The function G‐3‐ is only meant for service purposes. Please only use this function to put the unit in standby.
The LED Roller features a built‐in microphone which provides an auto sound active control. To enable this mode,
disconnect the LED Roller from the controller and select the desired Master Mode.
The LED Roller can be controller individually via your DMX controller. DMX controllers have different features and
functions. Please familiarize yourself to the controller you are using prior to addressing the units. The led display board
allows you to design the DMX address. For address setting press the MODE button until the display shows " A.001" and
set the desired address. After having addressed all the units, they can now be controlled via your DMX controller.
CHANNEL FUNCTION
CH. 1
CH. 2
CH. 3
CH. 4
CH. 5
LED ROLLER Manual
MASTER/SLAVE OPERATION
SOUND ACTIVE / STAND ALONE MODE
DMX CONTROL SETTINGS
DIMMER LIGHT ON / STROBE
PATTERNS
PATTERN ROTATION VIA LED MATRIX
X MOVEMENT
Y MOVEMENT
2009‐08‐01