Advertisement
This unit is intended for indoor use only.
Unit should be warmed up for 15 minutes before operating. For optimal effects, the system should be turned off
for 25 minutes after running continuously for 3 hours.
Ensure the power source is of the correct voltage for this fixture. Connect power through a direct switch circuit,
NOT a dimmer or variable circuit source.
Disconnect unit from power when not in use.
Do not install or operate the device in harmful environment conditions.
(i.e. extreme heat, cold, moisture or dust)
If the unit has been exposed to extreme environmental conditions or drastic temperature fluctuations,
ensure the unit is returned to room temperature before operating.
Do not block fan or ventilation slots while operating unit.
Do not move the device while in operation.
Do not aim smoke or bubble effects near unit.
Do not operate the unit during thunderstorms.
Disconnect power prior to servicing or cleaning unit.
Do not use solvents or abrasive cleaners to clean the unit. Use a damp cloth only.
Modification(s) to the device or power cord will result in termination of the dealer/manufacturer's warranty.
Use safety cable for added security when installing the unit by the hanging bracket.
Avoid direct eye contact with the light source.
Do not connect this unit to a dimmer pack.
The safest way to disconnect your power cord from main power is to grip cord end and detach from plug.
Do not leave unit unattended while operating for extended periods of time or overnight.
Contact the nearest dealer or service center for assistance with operating your unit. Unauthorized tampering
can cause additional damage. All units opened by an unauthorized user will not be covered under warranty.
Before installation, please make sure the power voltage matches your system requirements.
Make sure there are no flammable or explosive elements within 10 feet of the laser.
Unit must be installed at least 1 foot away from any wall.
Install the unit with the supplied hanging bracket.
The amount of maintenance is dependent on atmospheric conditions and frequency of use. The LED Roller should be
cleaned every 30 days to ensure maximum life expectancy. The housing must be cleaned with a damp, lint‐free cloth.
Never use alcohol or solvents to clean this unit. The lens should be cleaned every 15 days as it tends to build up
residue due to the use of fog/haze machines and use in smoking environments.
To ensure a proper function of the rotating parts, we recommend lubrication in six‐month intervals. Use small
portions of oil to avoid internal spillage.
Disconnect the power cord from the main power prior to using any liquid to clean your unit.
LED ROLLER Manual
IMPORTANT SAFETY INFORMATION
INSTALLATION
MAINTENANCE
2009‐08‐01
Advertisement
