Summary of Contents for OmniSistem Stinger 1 Series
- Page 1 STINGER LASER AERIAL and BEAM DEVICE (LABD) Stinger 1 Series User Information Guide For 2.0 Series Red, Green and Blue 4.95mW STINGER LASER Updated July 2009...
-
Page 2: Table Of Contents
This manual is written to guide you and help you become familiar with the features and capabilities of your new Stinger Laser. If you have any questions that are not answered here please visit our website at www.omnisistem.com or contact your local dealer. -
Page 3: Operating Instructions
OPERATION There are two modes of operation with the STINGER: 1. Stand-Alone Sound Activated Mode: Think of this as “Auto-pilot” The STINGER has a built-in microphone allowing it to go along with music. Note: Stingers are shipped in sound active mode (Mode 909) DMX Mode: Requires a DMX-512 control console for live pattern changes. -
Page 4: Dmx Table
Channel 3 Pattern Control 00-08 Beam Off 09-17 Beam Chase #1 18-26 Split Sky Horizontal 27-35 Split Sky Vertical 36-44 Flat Beam Fan 45-53 Rotating Beam Fan 54-62 Dual Counter Rotating Beam Fans 63-71 Tight Square Cone (rotates) 72-80 Dual Flat Beam Scan 81-89 Dual Sky (opens then closes) 90-98... -
Page 5: Cdrh Labeling
4. Install Bounce mirror. 5. For Permanent Installations we recommend the use of our bounce mirror installation bracket (OmniSistem Part # SL-GBM-BKT) 6. Target or redirect the beam to another location in the facility 7. Mark the spot where the laser is hitting and mount another bounce mirror there. Repeat this process for each beam until your installation is complete. -
Page 6: Fda Compliance
CAUTION: USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. STINGER 1 is CERTIFIED COMPLIANT BY: OmniSistem Lights and Effects 6403 South 208th Street Kent, WA 98032 253-395-9500 Phone... -
Page 7: Warranty
Warranty: OmniSistem Lights and Effects warrant the STINGER to be free from manufacturer defects for a period of 1 year from the date of purchase from OmniSistem or any of its Agents. Extended warranties may be purchased from any Authorized OmniSistem Dealer. -
Page 8: Stinger Tips
STINGER on, no fan, no laser - Verify correct power setting, switch “ON” If still no laser output, call OmniSistem Tech Support @ 253-395-9500 10am-4pm (PST) Tips: Always use your STINGER in a responsible manner. Here are some tips for use of the STINGER.