Specifications - Makita DJS160 Instruction Manual

ENGLISH (Original instructions)
1-1. Button
1-2. Red indicator
1-3. Battery cartridge
2-1. Star marking
3-1. Switch lever
4-1. Indicating lamp
5-1. Hex wrench
5-2. Screw

SPECIFICATIONS

Max. cutting capacities
Min. cutting radius
Strokes per minute (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting sheet steel and stainless
sheet steel.
Noise
The typical A-weighted
according to EN60745:
Model DJS100, DJS101, DJS161
Sound pressure level (L
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Model DJS160
Sound pressure level (L
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Explanation of general view
6-1. Center blade
6-2. Thickness gauge
6-3. Side blade
6-4. Hex wrench
6-5. Hex socket head bolt
7-1. Hex wrench
8-1. Oil supply
8-2. Center blade
Model
Steel up to 400 N/mm
Steel up to 600 N/mm
Aluminum up to 200 N/mm
-1
)
Overall length
Net weight
Rated voltage
noise level determined
) : 71 dB (A)
pA
) : 74 dB (A)
pA
value (tri-axial vector
DJS160
2
1.6 mm (16 ga)
2
1.2 mm (18 ga)
2
2.5 mm (13 ga)
250 mm
4,300
362 mm
1.9 kg
D.C. 14.4 V
ENE037-1
Model DJS100
Work mode : cutting sheet metal
Vibration emission (a
ENG905-1
Uncertainty (K) : 1.5 m/s
Model DJS101, DJS161
Work mode : cutting sheet metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model DJS160
Work mode : cutting sheet metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
ENG900-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
sum)
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
3
8-3. Pin
11-1. Limit mark
12-1. Brush holder cover
12-2. Notch
12-3. Screwdriver
13-1. Brush holder cap
13-2. Screwdriver
DJS161 DJS100
1.0 mm (20 ga)
0.7 mm (23 ga)
2.5 mm (12 ga)
2.0 kg 1.9 kg
D.C. 18 V D.C. 14.4 V
) : 12.5 m/s
h
2
) : 13.0 m/s
h
2
) : 12.0 m/s
h
2
DJS101
30 mm
4,300
364 mm
2.0 kg
D.C. 18 V
2
2
2
ENG901-1