Table of Contents
Advertisement
RTU Open Control System
The RTU Open control is factory- - mounted in the
48TC**16 unit's main control box, to the left of the CTB.
See Fig. 66. Factory wiring is completed through
harnesses connected to the CTB. Field connections for
RTU Open sensors will be made at the Phoenix connectors
on the RTU Open board. The factory- - installed RTU Open
control includes the supply- - air temperature (SAT) sensor.
The outdoor air temperature (OAT) sensor is included in
the FIOP/accessory EconoMi$er2 package.
Fig. 65 - - RTU Open Multi- - Protocol Control Board
Fig. 66 - - 48TC**16 Control Box Component Locations
The RTU Open controller is an integrated component of
the
Carrier rooftop unit.
programming provides optimum performance and energy
efficiency. RTU Open enables the unit to run in 100%
stand- - alone control mode, Carrier's I- - Vu Open network,
or a Third Party Building Automation System (BAS).
On- - board DIP switches allow you to select your protocol
(and baud rate) of choice among the four most popular
protocols in use today: BACnet, Modbus, Johnson N2 and
LonWorks. (See Fig. 65.)
Refer to Table 8, RTU Open Controller Inputs and Outputs
for locations of all connections to the RTU Open board.
32
Its internal
application
C10811
C10810
Advertisement
Table of Contents
