Etac Molift Air 200 Quick Manual

Molift Air 200 / 350
Quick guide
QG16601 Rev. A 2020-10-29

Hoist components:

1. Trolley
2. Hoist
3. Side covers
4. Emergency Stop/ Emergency
lowering
5. Lifting belt
6. Quick release pin
7. Hand control
8. Sling bar

General information:

Lift and transfer of a client will always pose a certain
risk and only trained personnel are allowed to use the
equipment and accessories covered by this user manual.
The rail system must be installed by certified personnel in
accordance with applicable installation instructions. The
lifter is not intended to be operated by the client being
lifted.
Only certified personnel are allowed
to open hoist or accessories to perform
service or repair.
Read User Manual before use! This Quick
guide does not replace User Manual. It is
important to fully understand the content
of the user manual before attempting to
use the equipment.
4
5
6
1
2
3
7
8

Battery / Charger indicator:

Wrench symbol / Service
indicator
Battery symbol / Battery
indicator
Charger indicator Mode
Green flash
Yellow
Yellow flash
Green
The Hand control has 2 buttons
for lifting and lowering, or 4
buttons if the hoist is equipped
with propulsion. The Hand control
has an indicator light that will illu-
minate when battery level is low
and the lifter requires charging
Not connected to hoist
Charging
Top of charge
Fully charged