Curtis OMGS 3PH Service Manual page 2

https://appliancetechmanuals.com
Your Curtis G4/Gold Cup Series is Factory Pre-Set for Optimum Performance.
After connection to water and power; turn on the brewer at the rear toggle switch. You will hear a beep and the status lights will come on for a moment.
The screen will display
MODEL NUMBER
CONTROL BD NUMBER
When the proper level is reached
Control will display
READY TO BREW
COFFEE BREWING INSTRUCTIONS
1. Brewer should be ON. Confirm this at the main toggle switch on the right side of the brewer. The touch screen should read Ready to Brew.
2. Place an empty coffee container centered beneath the brew cone.
WARNING – AVOID SCALDING: USE BOTH HANDLES FOR BETTER CONTROL. The brew cone may be filled with hot coffee
grounds and is difficult to manage with one hand.
The coffee vessel is heavy when full. Take precautions to avoid dropping while moving.
3. Place a new paper filter into the brew
cone.
6. Start the brew cycle by hold your finger
on the desired brew icon. As soon as
you hear the click of the brew valve, the
brew cycle has started and you can lift
your finger.
Brew Code: You may find that when a brew
button is pressed, a key pad appears on the
screen. This is a brew lock-out feature that
2
. Next is displayed. Water will fill the tank (3-5 minutes depending on water flow rate).
FILLING
will appear on the screen. It takes approximately 45 minutes to reach the set point temperature.
HEATING
when temperature reaches the set point. The unit is now ready to brew.
4. Fill the brew cone with the proper
amount of ground coffee.
requires a code to be entered before a brew
will start. The default is OFF.
CAUTION: When enabled, as soon as you
enter the brew code a brew cycle starts.
Refer to page 8 for more information about
the Brew Code.
5. Transfer the filled brew cone to the
brewer.
During the brew cycle, an animated
3 gallon server icon will appear on
the screen and a brew timer will
count down the time remaining on
the brew cycle.